Tagging Piles for Measurement (Full-Service Aerials)

Updated on October 7, 2025

When scheduling your full-service aerial flight, specify which piles you want measured by tagging them in your system.

Pre-Flight Tagging

Before your scheduled flight, mark all piles that should be measured:

1. Log in to your account
2. Go to your site layout
3. Mark each bunker or pile location
4. Add identifying information
5. Note any special instructions for measurement

During Flight Coordination

Your designated contact will communicate with the pilot regarding:

• Which specific piles require measurement
• Special access requirements
• Any hazardous conditions to avoid
• High-priority measurement areas

Post-Flight Verification

After the flight, verify all intended piles were captured:

• Review the aerial image
• Confirm all tagged piles are visible
• Check measurement accuracy and completeness
• Note any measurement anomalies